Ecumaster Digital ECU Tuner 3 piggyback

Technical details:

• four 16x16 side tables (fuel map,two PWM tables, ignition table)
• 8 Correction tables 16x1
• 2 independent switchable map sets 
• possibility modification of one analogue signal
• 4 analogue inputs
• in-built Data Flash – possibility of logging without connected PC
• battery voltage monitoring 
• support of frequency output air flow meter (possibility of signal modification) 17Hz-4kHz
• support VR and Hall effect crank sensors together with ignition modules pulse. Device support both single ended and differential signals
• supports a lot of crank trigger patterns :60-2, 36-2, 36-1, Multitooth, Ignition Modules and more
• support of waste gate valve
• output for 4 saturated injectors ("full group")
• ON/OFF parametric output
• automatic conversion of MAP to MAF with the use of the learning algorithm
• launch control
• road dyno
• possibility individual calibration of each analogue sensors – device displayed values with correct units
• free firmware update – new crank trigger patterns and new functionality
• fuel Implant mode –possibility of drive injectors in standalone mode (batch fire)
• USB communication no additional interface needed
• 24 months warranty

PC Requirements:

To properly work with the DET3 device following minimum is required.

• Windows 2000, XP, Vista, Windows 7, Windows 8
• Screen resolution of at least 1024x768 16bit
• CPU with a clock of at least 600MHz
• USB port

What is in the box

• Digital Ecu Tuner 3 device
• USB AA lead
• connector
• set of terminals
• CD with software necessary drivers and user manual
• set of resistors and diode which may be useful during installation

Available as standard version and with integrated 400KPA MAP-sensor