Description / Supercharger Drive Snout Coupler
A drive snout coupler is used to make the connection between the belt driven shaft and the rotor pack. By using a coupler the largest vibrations and shocks in the drive line can be absorbed. These supercharger drive snout couplers can brake down. If this happens these can act as a replacement.
All drive snout couplers are made of carbon fibre and are the same or better quality then original.
Available in 3 versions:
Type 1:
- Outerdiameter: 47,5mm
- Innerdiameter: 19mm
- Centre distance: 33mm
Suited for most Eaton M- & MP-models and TVS superchargers smaller then TVS1320.
Some of the models above are equipped with a spring loaded coupler. These springs tend to break at their mounting points. This snout coupler can also be used to replace the spring coupler for these models. As this coupler has less slack you might hear a bit more supercharger noise.Â
Type 2:
- Outerdiameter: 51mm
- Innerdiameter: 19mm
- Centre distance: 33mm
Suited for most TVS superchargers size 1320 and up.
Type 3:
- Outerdiameter: 51,5mm
- Centre distance: 35,5mm
Suited for most Lysholm superchargers.
Besides the models mentioned above these couplers are used in many other supercharger models.
More Information
SKU | Supercharger_universeel_1902 |
---|---|
Product Brand | Chargertech |
Sold per | 1 |
Car Brand | Universeel |